Pelican 1510TPF Carry-On Case with TrekPak/Foam Hybrid (Black)

Pelican™ Protector Case™

Sensitive equipment needs protection, and since 1976 the answer has been the Pelican™ Protector Case. These cases are designed rugged, and travel the harshest environments on earth. Against the extreme cold of the arctic or the heat of battle, Pelican cases have survived.

Made in the USA, these tough cases are designed with an automatic purge valve, that equalizes air pressure, a watertight silicone O-ring lid, over-molded rubber handles and stainless steel hardware.

• Pick N Pluck™ with convoluted lid foam

• Watertight, crushproof, and dustproof

• Open cell core with solid wall design - strong, light weight

• Automatic Pressure Equalization Valve - balances interior pressure, keeps water out

• O-ring seal

• Stainless steel hardware

• Lifetime Guarantee of Excellence

The black Pelican 1510TPF Carry-On Case with TrekPak/Foam Hybrid is an unbreakable, watertight, airtight, dustproof, chemical-resistant, and corrosion-proof hard case used to carry any kind of equipment that needs to be protected from the elements. It is made of an ultra-high impact structural copolymer that makes it extremely strong and durable. It has a 0.25" neoprene O-ring and includes an automatic purge valve for quick equalization after changes in atmospheric pressure. It has a hinged case with double ABS latches that seal perfectly, and padlock protectors that provide added strength and extra security against cutting and theft.

The 1510TPF comes with long side handles, a long front handle, retractable extension handle, and strong polyurethane wheels with stainless steel bearings. It has an effortless release latch for the extension handle. The case meets current FAA requirements for carry-on luggage.

Besides being lighter than traditional padded dividers, the TrekPak Divider System uses pre-installed wall sections, divider panels, locking pins, and an easy-to-use cutting tool. Simply lay your gear in the case, measure and cut the divider sections, and lock them in place with the steel U-pins. Extra divider material is included for occasions where your equipment requirements vary. The 7/16" thick divider sections are made of waterproof, closed-cell foam that is laminated to a rigid, corrugated plastic panel that resists tearing and shredding. The TrekPak is combined with a 1" bottom foam and lid foam to give your gear 360-degree protection. This TrekPak/Foam Hybrid configuration combines the benefits of TrekPak dividers with a pick-n-pluck foam section.

Unbreakable, watertight, airtight, dustproof, chemical-resistant, and corrosion-proof case

TrekPak dividers, cutter tool, pins, pull tabs, pick-n-pluck foam section, plus a top and bottom foam piece.

On Board

Meets current FAA requirements for carry-on luggage

• Note: Requirements are subject to change; always check with your carrier

• Made of ultra-high impact structural copolymer that makes it extremely strong and durable

• Built-in purge valve for changes in altitude or temperature

• Temperature rating of 10° to 210°F

Carrying Options

• Front large folding haul handle

• Large side folding haul handles

• Retractable extension handle

• Strong built-in polyurethane wheels with stainless steel bearings

Padlock protectors provide added strength and extra security against cutting and theft

Key Features

• Watertight, Dustproof Case

• Made of Ultra-High Impact Copolymer

• Three-Piece Foam Set is Included

• ABS Double Throw Latches

• Built-In Purge Valve

• Front Large Folding Haul Handle

• Large Side Folding Haul Handles

• Retractable Extension Handle

• Polyurethane Wheels with SS Bearings

• Dimensions

  Interior (L×W×D)

  19.75 x 11.00 x 7.60 in (50.2 x 27.9 x 19.3 cm)

  Exterior (L×W×D)

  22.00 x 13.81 x 9.00 in (55.9 x 35.1 x 22.9 cm)

Pelican 1510TPF,WL/TPF INSERT,BLACK